Wicketed Bags: How Wicket Packs Work and What to Put on Your Spec

Wicketed Bags: How Wicket Packs Work and What to Put on Your Spec

Wicketed bags are pre-made poly bags stacked on a wire or plastic pin, called a wicket, through two holes in an extended lip. The operator or machine opens the top bag, fills it and tears it off the lip, and the next bag is ready. In US stock, the common bread bag is 1 mil LDPE with a bottom gusset, 250 bags to a 5 in wicket. Here is how wicket packs work, which details your bagger cares about, and what to write on a spec or RFQ.

How a wicket pack works

A wicketed bag is a side-welded bag with one wall longer than the other. The longer wall is the lip. Two holes are punched in the lip and the stack is threaded onto a U-shaped wicket. Scientex, a Malaysian film maker, notes that the wire or a plastic spool holds the stack through those two holes, with rubber or plastic grommets to keep it tight.

The open side faces the operator. On a hand line, an air blower puffs the top bag open (Interplas sells one made for bags on wicket). The worker slides in a loaf or a scoop of produce, pulls, and the bag tears free. Uline calls it “load and tear”.

On an automatic or semi-automatic bagger, the wicket sits on pins and the machine opens, fills and often closes the bag. Newtec’s wicket bagger for potatoes, carrots and apples is rated at up to 25 bags per minute for bags 220–320 mm wide and 300–550 mm tall, with a clip or tape closer. Interplas lists its wicketed ice bags for automatic wicket baggers and bulk ice baggers.

For the basics of the bag style, see our earlier post What is a wicketed bag?. This guide is about the details that decide whether a pack runs on your line.

Wire wicket, plastic wicket or no wicket

  • Wire wicket. The usual choice for bakery bags. Uline ships its bread bags on a wire wicket, 250 bags each.
  • Plastic wicket or spool. Common on ice bags. The Interplas 8 lb ice bag comes on a plastic wicket, 250 bags each.
  • No wicket. If you fill by hand and speed is not the issue, loose bags or bags on roll may cost less. A wicket earns its place when the same bag is filled hundreds of times an hour.

Wicket holes and spacing

The two holes must match the pins on your stand or machine. The WebstaurantStore custom-order sheet lists what a buyer has to fix: wicket length of 3–6 in, wicket width (the space between the two legs) of 3–9 in, and 100–350 bags per wicket. Its stock bread bags all sit on a 5 in wicket.

Spacing is not always written the same way. One Interplas ice bag page gives the plastic wicket as 6 in in the spec table and 7 in on center in the feature list. Send a drawing or a sample bag, and measure center to center. A pack that is 1 in off will not sit on your pins.

The lip and how the bag releases

The lip is the extra film above the bag mouth that carries the holes. Interplas lists its 9.25 x 14.5 in bread bag with a 2 in lip. The WebstaurantStore sheet asks you to pick a lip length and a release: a perforated lip, or tear starts (small notches that start the tear). The lip stays on the wicket. Packs can also carry a cardboard header on the front, back, both or none to stiffen the stack.

Bottom gusset or side gusset

The stock bread bags we found at Uline and WebstaurantStore are bottom gusseted, apart from lay-flat baguette bags. The bottom folds in so the bag sits square around a loaf. WebstaurantStore uses a 2.5 in gusset on its smaller bags and 4 in on the rest. A side gusset folds in along the sides instead and suits tall, block-shaped packs. Gusset depth changes how wide the mouth opens, so check it against your funnel or product width.

Vent holes and microperforation

PPC Flex, a US packaging maker, notes that vent holes release gas so a closed bag does not burst. Microperforation is a finer version: WebstaurantStore says its microperforated bread bags let moisture and heat escape to keep bread crisp. Interplas sells a vented HDPE greens bag at 0.6 mil, 17 x 18 in with a 6 in bottom gusset, 200 bags per wicket. Ask for vents only where they help. A vent in an ice bag means water on the floor.

HDPE or LDPE

  • LDPE is clear and soft and seals well. It is the default for bread. Uline names LDPE, and the polyethylene bread bags on the WebstaurantStore sheet are all 1 or 1.25 mil.
  • HDPE is stiffer, slightly cloudy and strong at low gauge. It suits produce where you want a thin, crisp bag, like the 0.6 mil greens bag above.
  • Ice and freezer bags run thicker. The Interplas 8 lb ice bag is 1.5 mil with EVA and metallocene for strength and a freezer-grade resin, rated down to -20°F.

Our wicket bag size and thickness guide goes further on gauge.

Typical US stock sizes

From current Uline, WebstaurantStore and Interplas listings. Sizes are flat width x length, plus bottom gusset.

Use Size (W x L + gusset) Gauge seen Example listings
Small loaf, rolls 7 x 13 + 3 in; 7.25 x 13.125 + 2.5 in 1 mil Uline (holds 2 lb); WebstaurantStore
Standard loaf 9.25 x 15.25, 10 x 15, 10 x 16 + 4 in 1 mil WebstaurantStore; Uline 10 x 16 x 4 (holds 4 lb)
Large loaf, buns 11 x 17, 11 x 18, 12 x 19 + 4 in 1 mil WebstaurantStore; Uline 12 x 19 x 4 (holds 5 lb)
Bulk bakery 14 x 20 + 4 in 1.25 mil Uline (holds 8 lb); WebstaurantStore
Baguette 6 x 28 in, lay-flat, microperforated 0.8 mil PP WebstaurantStore
8 lb ice 11 x 19 + 3 in 1.5 mil Interplas, plastic wicket
Greens, produce 17 x 18 + 6 in, vented 0.6 mil HDPE Interplas, 200 per wicket

Typical uses follow the table: bread, buns and bagels; fresh produce such as potatoes, carrots, apples and greens; ice; and frozen food where a freezer-grade resin is part of the spec. Scientex also lists diapers and sanitary products on automatic lines.

What to put on a wicket bag spec or RFQ

  • Flat width x length in inches, and gusset type and depth
  • Lip length, and release: perforated lip or tear starts
  • Wicket hole size, center-to-center spacing and wicket length
  • Wire wicket, plastic wicket or spool, and grommets
  • Bags per wicket, and cardboard header: front, back, both or none
  • Gauge in mil, and resin: LDPE, HDPE, blend or freezer grade
  • Vent holes or microperforation, with size and position
  • Food contact requirement, colour and print
  • Bagger make and model, plus a sample bag that already runs on it

The last point saves the most time. One sample tells us hole size, spacing and lip in one go.

How we can help

We make poly wicket bags to your size, thickness and colour. Food-contact bags are FDA-compliant (21 CFR 177.1520). We print by gravure up to 8 colours, one or both sides, match film colour to Pantone, and add a white base layer on clear film when you need it. Cylinders are kept up to 2 years, so a reorder in that time needs no new plates. We pack to your carton design with item codes, barcode labels and shipping marks, and every item carries a tracing number for quality control. Our plants work to ISO 9001 and Japan’s JIS standard. Lead time is 4–6 weeks for a first order and 3–4 weeks for a repeat. For hand-filled produce we also make produce bags on roll. Free samples.

Frequently asked questions

How many bags are on one wicket?

250 is the usual count on US stock bread and ice bags. Custom packs run from about 100 to 350.

What thickness are wicketed bread bags?

Most are 1 mil LDPE. The largest stock size, 14 x 20 in with a 4 in gusset, steps up to 1.25 mil.

Will your wicket bags fit my bagging machine?

Yes, if hole size, hole spacing, lip and wicket match your pins. Send a bag that already runs on the machine, or the machine’s bag drawing, and we build to it.

Can wicket bags have vent holes?

Yes. Vents or microperforation are common on produce and bread bags. Leave them off ice bags.

Want a quote on your own wicket bag spec? Contact us or WhatsApp +84 898 545 893.

Sources: Uline Wicketed Bags; WebstaurantStore wicketed bags spec sheet; Interplas 9.25 x 14.5 in wicketed bread bag; Interplas 8 lb wicketed ice bag; Interplas vented greens bag on wickets; Scientex wicket bags; PPC Flex wicketed bag styles; Newtec PEB41 wicket bagger.